Lilypad - Touch Sensor

Force Sensitive Resistor (Touch Sensor)


This Force Sensitive Resistor allows you to measure the pressure from a finger press.


1. In order to use this sensor one side of it first needs to be soldered to a 10K resistor (Note don't do this yourselves- ask us).
2. Connect the free end of the sensor to the + petal on the Lilypad.
3. Connect the resistor end of the sensor to an analog input pin e.g. a0.
4. Connect the free end of the resistor to the - petal on the Lilypad.

NB: If you are using alligator leads to prototype then make sure that the teeth of your clips make good contact with the metal parts of the sensor petals. If not, you will get inconsistent results.

Touch Sensor Connected to Lilypad

Getting Data From:

Getting data from any analog input involves writing a sketch to read that input using the anlogRead() function. A good basic example of this is the Arduino example AnalogInSerial sketch (File > Examples > Analog > AnalogInSerial). This sketch will read any analog input and then output the result to the serial monitor. This is a good way to check the range of values that your sensor is giving.